|
3d Tools
|
|
08-14-2005, 02:18 AM,
(This post was last modified: 08-14-2005, 07:33 AM by WIdiver_Paul.)
|
|||
|
|||
|
3d tools, Mt. Everest revisited
I'm getting ready to start applying this to some shipwreck work and wanted to see if I could 'fix' something that's already been done, but is flawed, to determine whether it's possible to re-split images to be applied to a 3d wraparound.
What better image to use than a panorama taken from the top of Mt. Everest ! Below is the original, with the messed up 'tails' that needed to be cropped and the image needed to be re-split into 4 overlapping sections again to feed it back into A3d for stitching. Notice the image is actually about 390 degrees. When , there ends up being a noticeable seam in the image, the equivalent of a crooked label on a wine bottle. |
|||
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
3d Tools - by WIdiver_Paul - 07-30-2005, 07:41 AM
Re: 3d Tools - by WIdiver_Paul - 07-30-2005, 08:04 AM
Re: 3d Tools - by WIdiver_Paul - 07-30-2005, 06:19 PM
Re: 3d Tools - by jasondbaker - 07-30-2005, 09:46 PM
3d tools, Mt. Everest revisited - by WIdiver_Paul - 08-14-2005, 02:18 AM
3d tools, Mt. Everest revisited - by WIdiver_Paul - 08-14-2005, 02:23 AM
Re: 3d Tools - by Carvendive - 08-22-2005, 01:41 PM
Re: 3d Tools - by WIdiver_Paul - 08-22-2005, 02:37 PM
Re: 3d Tools - by ethanb - 08-22-2005, 03:26 PM
Re: 3d Tools - by Carvendive - 08-23-2005, 12:51 PM
|
Users browsing this thread: 1 Guest(s)