valves - Printable Version +- wiscuba.com (http://www.wiscuba.com/forum) +--- Thread: valves (/showthread.php?tid=2456) |
valves - ttph - 07-02-2011 A fella I dive with was telling me that he took the springs out of the valve knobs on his twinset to make them less resistant to turning in the event that a shutdown is necessary. Anyone else heard of this? Is it a pretty common practice? I did dive his set of twins and practiced shutdown drills, and I will agree that they are considerably easier to crank, especially if you aren't getting a full grip on the knob, but rather a finger or two. Matt Re: valves - jeffberry - 07-02-2011 Never heard of that! If your doing anything over head I would think a bit of tension is a good thing! Are you comming to Fortune tomorrow with the other Matt? Re: valves - matt t. - 07-02-2011 I've never heard of that and would probably say it's not a good idea. The spring tension is needed to keep tension on the stem and valve knob, and to keep the end of the stem and plug/seat from getting damaged when you open/close the valve by keeping them in position. If you properly clean and lube your valves at service time they should be pretty smooth. Re: valves - ttph - 07-03-2011 Glad I asked. Jeff- I just got back into town. Matt, Todd and I made pretty good time round-trip. Great day of diving with killer viz. Too bad you couldn't make it, but I heard you were out on the big pond. Sounds like fun. Matt Re: valves - jeffberry - 07-03-2011 Oh I just could not pass on a flat calm day on the lakeland! Dove it with out a problemthat was a great tune up for me! Glad you guys had a good time Re: valves - ttph - 07-03-2011 I would suspect that we'll be up again in the coming weeks. Maybe we'll meet up then. Matt |